Every sample Dr PRP kit comes with the following: ONE DrPRP Plasma Separation kit. Each DrPRP tube also comes with it's own anticoagulant. This prp kit comes with 30 days of complimentary support. You can contact Dr. PRP specialists for consultation and clarification anytime during the 30 days.
This is a sample only – NO RETURNS OR REFUNDS FOR THIS PURCHASE.
With Dr. PRP Platelet separation kit, it’s easy to collect your patient’s blood and turn it into highly concentrated (platelet-rich) plasma. Dr.PRP uses a simple, innovative design to efficiently capture the majority of the patient’s platelets. Click the button below to watch video now.
Accelerated Natural Healing With PRP
With Dr. PRP Platelet separation kit, it’s easy to collect your patient’s blood and turn it into highly concentrated (platelet-rich) plasma. Dr.PRP uses a simple, patented design to efficiently captures the majority of the patient’s platelets.
The blood samples taken from the patient are transferred to Dr. PRP kit for Platelet separation using a centrifuge. The final compoents of the blood will be the red blood cells, the platelets, and the plasma.
When platelets become activated, growth factors are released and initiate the body’s natural healing response.
97% Platelet Recovery Rate
Platelet concentration determines the efficiency of a good PRP separation system regardless of the volume of Platelet Rich Plasma (PRP) produced. Dr. PRP uses a specific filter and a recommended centrifuge speed to achieve a high platelet recovery rate of 97% or more (platelet counts up to 2,000,000 per µl of blood.)
– Promotes formation of extracellular matrix
– Regulates bone cellmetabolism
Vascular Endothelial Growth Factor (VEGF)
– Promotes angiogenesis
Epidermal Growth Factor (EGF)
– Promotes cell differentiation and stimulates
– Re-epithelialisation, angiogenesis and collagenase activity
Fibroblast Growth Factor (FGF)
– Promotes proliferation of endothelial cells and fibroblasts
– Stimulation of angiogenesis
The higher the platelet recovery, the more concentrated the platelets which leads to more faster healing for your patients.”
How To Use Dr. PRP For Platelet Separation
In a 20 cc syringe take 2 cc of anticoagulant, then draw 18cc of blood from a subject (final volme : 20 cc).
Inject the drawn blood to Dr.PRP kit through the upper injection port until the blood level reaches the 20cc scale marked on the kit. (For easier injection, tilt the kit)
- Separate the plasma layer and red blood cell (RBC) layer by the first centrifugation. (Prior to centrifugation, balance the weight of kit with counterbalance)
- Conditions for the First Centrifugation (RPM)
Female - 3,000 RPM 3 minutes
Male - 3,000 RPM 4 minutes
When fail the seperation - 3,000 RPM 1 minutes
*For subjects taking aspirin, antihypertensive drugs, with cardiac disease, anemia, or during menstruation, the centrifugation should be done for 4 min at 1,000 RCF.
After the first centrifugation, identify the separation position of the plasma and the RBC layer. Then adjust the height of the separated boundary to the indicated point by pushing up or pulling down the adjusting knob located at the lower part of the Kit. (If the volume of the plasma layer or the separation is not quite well done, additional centrifugation may be done for about 1-2 min at same RPM)
In order to block the plasma and the RBC layer completely, fasten the adjusting knob (counter-clockwise) located at the lower part of the Kit. Then fasten the valve(counter-clockwise) just above the adjusting knob. Finally fasten the adjusting knob(counter-clockwise) again.
Put the fastened PRP Kit to the centrifuge with counterbalance for the second centrifugation to enrich the concentrated platelet.
*Condition for the second centrifugation : 6 min at 3,200 RPM
Place the PRP Kit in its upright position with care in order to prevent mixing of the separated PRP and PPP. Open the upper sillicone lid on the Kit. Using a 10cc syringe with a long needle (> 5 cm) take out the PPP layer slowly from the upper part leaving 4 cc at the base.
Shake and mix the remaining 4 cc of the PRP layer. Then administrate the PRP.
Expertly written by leading scientists in the field, this book provides for beginners and experienced readers scientific fundamentals, the state of art of PRP, specific uses and personal experiences with a practical approach and reference for current trends in use.
Only logged in customers who have purchased this product may leave a review.